DKS GmbH - Produkte
Trust is good. Measuring is better!
Designation: Transmitter for extractive gas analysis

The small transmitter FTC130 for extractive measurements is based on the thermal conductivity principle. The gas path is made of stainless steel and is pressure-resistant up to 20 bar. Linearizations of up to 16 gas mixtures are stored in the device for easy adjustment to changing measuring requirements.

It provides comfortable parameterization, visualization and adjustment through the PC interface SetApp2.0. A potential-free output of 4-20mA as well as the RS232/485 interface enable the reading of measured values also the remote control of the devices.

Specification

General:
Measurement process Thermal conductivity
Sampling Transmitter extractive
Connection 6mm pipe
Dimensions (WxHxD in mm) 144x50x50
Protection class IP 65
Pressure-proof to 20 bar absolute
Power supply 18V to 36V DC / 700mA
Ambient temperature range -20°C to 50°C
Weight to 700 g
T90 time at 60l/h < 1sec
Communication:
RS232 Yes
Current output 2x, 0/4-20 mA
Voltage output
Display
Relays
Service program SetApp 2.0 Yes
Calibration on site Yes
Options
Flow measurement
Flow monitor
Infrared measurement
Multi Gas Mode Yes
Protection against corrosion Yes
Protection against condensate and dust Yes
Suitable for inflammable gases Yes
Moisture measurement
Cross-sensitivity compensation
Specifications gas analysis
Noise < 1% of smallest range
Drift at zero point per week < 2% of smallest range
Repeatability < 1% of smallest range
Non-linearity < 1% of range
Measuring error with ambient temperature change per 10°K < 1% of smallest range
Flow influence between 60l/h and 90l/h per 10l/h < 1% of smallest range
Fault with measurement gas change (Pabs > 800 hPa) per 10 hPa < 1% of smallest range
« Back to overview
This email address is being protected from spambots. You need JavaScript enabled to view it.